Automatic control for water pump(SK-Ⅹ)

Descriptions:
    The unit can replace all the components installed on the automatic water pump such as manometer, pressure switch, triple valve, check valve and pressure tank. Thus it is called the five-in-one control.
   The unit can perform steadily. It needs very little maintenance and can keep a long span-life. When the unit is connected to the electrical network, the green led “Power On”lights up and the yellow led “On”(Pump in operation)indicates that the pump has been started. The pump continues to operate for a few seconds enabling the system to fill in the pipes and to reach the required pressure. If this lapse is insufficient, the red led“Failure”lights up. In this event, keep the “Reset”button pressed and wait, with a tap opened, until the red led is off. Once released the button and closed the tap , the unit stops the pump at its maximum pressure.

Functioning:
   The starting operation archived, the unit is programmed to perform all the pump control operations automatically. When particular operational breakdowns occur, such as water failure, obstruction of the suction pipe, ect.,the unit recognizes the breakdown and red led“Failure”lights up, at the same time a stop signal is sent to the pump to prevent damages caused by its working in the absence of water. Rectification of the failures that have caused the blockage, allows the system to be restared by pressing the“Reset”button.